Siemens SINUMERIK 840D sl Series User Manual

Error Codes of Alarm 300500 08/2005
4-984
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Error code 0035H
Error text Error in software boot section 2
Extension 1 0 or incorrect address
Extension 2 0x60 ;Illegal SERVO reaction on STF handshake
0x61 ;Error during RAM check
0x62 ;Transport checksum does not correspond to that of the SERVO.
Explanation Errors were detected on loading the drive software. The cause is either faults during the
transfer via the drive bus or a defective control module.
Remedy Check the drive bus cable and cable connections, perform remedial measures (check
shielding or ground connection), replace control module.
Error code 0040H
Error text Incorrect number of specified current state filters
Extension 1 -
Extension 2 -
Explanation An illegal number of current setpoint filters (> 4) has been entered.
Remedy Correct number of current setpoint filters (MD 1200)
Error code 0041H
Error text Incorrect number of specified rotation speed state filters
Extension 1 -
Extension 2 -
Explanation An illegal number of speed setpoint filters (> 2) has been entered.
Remedy Correct the number of speed setpoint filters (MD 1500).
Error code 0044H
Error text Difference GROBSYNC/FEINSYNC too great.
Extension 1 -

Siemens SINUMERIK 840D sl Series Specifications

General

Control Type	CNC
PLC	Integrated SIMATIC S7-300
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Max Axes	31
Programming Languages	DIN/ISO 66025, high-level language (C/C++), Siemens programming languages (e.g., ShopMill, ShopTurn)
Safety Features	Integrated safety functions (Safety Integrated)
Operating System	Windows-based
Drive Interface	SINAMICS S120
Applications	Milling, turning, grinding, laser
Display	TFT color display, various sizes