Siemens SINUMERIK 840D sl - Multitouch operation with SINUMERIK Operate; 3.1 Multitouch panels

08/2005 Overview of Alarms
2-69
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
6416 Channel %1 tool %2 with tool edge no. %3 has reached tool monitor warning limit
Parameters: %1 = Channel number
%2 = Tool identifier
%3 = Cutting edge number
Definitions: This message informs that at least one cutting edge of the time or quantity monitored tool
has reached its monitoring limit. The limit was detected in the channel context. The alarm
originated during NC program execution.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: For information only. The user must decide what to do.
Program Con-
tinuation:
Clear alarm with the Delete key or NC START.
6417 TO unit %1 tool %2 with tool edge no. %3 has reached tool monitoring limit
Parameters: %1 = TO unit
%2 = Tool identifier
%3 = Cutting edge number
Definitions: This message informs that at least one cutting edge of the time or quantity monitored tool
has reached its monitoring limit. The alarm was triggered through the OPI interface
(MMC, PLC). The channel context is not defined. The TO unit was specified for this rea-
son.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: For information only. The user must decide what to do.
Program Con-
tinuation:
Clear alarm with the Delete key or NC START.
6418 Channel %1 tool %2 with tool edge no. %3 has reached tool monitoring limit
Parameters: %1 = Channel number
%2 = Tool identifier
%3 = Tool number
Definitions: This message informs that at least one cutting edge of the time or quantity monitored tool
has reached its monitoring limit. The limit was detected in the channel context. The alarm
originated during NC-program execution.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: For information only. The user must decide what to do.
Program Con-
tinuation:
Clear alarm with the Delete key or NC START.
6421 Channel %1 tool move not possible. Empty location for tool %2 Duplo no. %3 on
magazine %4 not available.
Parameters: %1 = Channel ID
%2 = String (identifier)
%3 = Duplonummer
%4 = Magazine number
Definitions: The desired tool motion command - triggered from the MMC or PLC - is not possible. The
tool cannot be moved into the specified tool magazine. There is no appropriate location
for this tool.
Reactions: - NC Start disable in this channel.
- Interface signals are set.