Siemens SINUMERIK 840D sl - Page 957

08/2005 List of Action Numbers
3-957
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
No. 36
No. 37
No. 38
No. 39
No. 40
Explanation Start machine-data processing (INI file is located externally, e.g., on MMC)
(PI command).
Not allowed if -
Remedy -
Explanation Stop because of mode group single block. VDI signal, single type A (only executable
blocks), after stop in another channel in this mode group.
Not allowed if -
Remedy -
Explanation Stop because of mode group single block. VDI signal, single type B (any blocks), after
stop at end of block in another channel in this mode group.
Not allowed if -
Remedy -
Explanation Stop because end of overstore buffer "_N_OSTOREXX_SYF" has been reached.
Not allowed if -
Remedy -
Explanation Start preprocessing (NC block: Stopre)
Not allowed if -
Remedy -