Siemens SINUMERIK 840D sl Upgrade Instructions

SINUMERIK 840D sl 2010-11-26
Upgrade Instructions
SINUMERIK Operate 2.6 SP1 HF3 for PCU 50.3
© Siemens AG 2010 Page 5 of 5
please check the settings made under Control Panel / Set PG/PC Interface. In addition to S7ONLINE, an
Access Point
SINUMERIK_CP (SINUMERIK 7xx) -> TCP/IP -> VIA Rhine III Fast Eth. ..<Board 2>
must be included. If necessary, configure this Access Point as indicated.
• Editor: The key combination Shift+Insert must be used to edit cycle calls directly in the DIN code. At present,
this is not provided on all SINUMERIK OPs. Remedy: Use an external PC keyboard.
• With the installation version "Operation on SIMATIC-CPU 317 / 319", the internal editor is not functional. Use
an external editor (e.g. notepad, wordpad).
• To operate the simulation NC-MD $MC_FRAME_ACS_SET must be set to 1.

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based