Overview of Alarms 11/2006
HMI alarms
2-660
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
109010 Displacement: error in internal state
Definitions: --
Remedy: --
109011 Switchover: trace file cannot be created
Definitions: --
Remedy: --
109012 Operator units switchover, PLC timeout: 002
Definitions: --
Remedy: --
109013 Activation denied
Definitions: --
Remedy: --
110000 No data available for display
Definitions: --
Remedy: --
110001 Cannot read ACC variable:%1
Parameters: %1 = --
Definitions: --
Remedy: --
110002 No memory available
Definitions: --
Remedy: --
110003 COM file not found: %1
Parameters: %1 = --
Definitions: --
Remedy: --
110004 Screen not found: %1
Parameters: %1 = --
Definitions: --
Remedy: --
112045 Several approach points required
Definitions: Several insertion points are required for machining the contour pocket. The machining breaks up into
several individual machinings.
The program can be started.
This alarm is only a warning.
Residual material will remain.
Reaction: Alarm display.
Remedy: By using a smaller milling cutter, the machining could be done with an insertion point.
Program
Continuation:
Internal
To Next Page
Loading...
