Siemens SINUMERIK 840Di - Page 536

Overview of Alarms 11/2006
NCK alarms
2-536
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61305 Channel %1 Block %2: Dimension too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program
Continuation:
Clear alarm with the RESET key. Restart part program
61306 Channel %1 Block %2: Permissible measuring difference exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE971, CYCLE972, CYCLE974, CYCLE977, CYCLE978,
CYCLE979, CYCLE982, CYCLE994.
Remedy: -Check setpoint value
-Increase parameter _TDIF
61307 Channel %1 Block %2: Incorrect measuring variant
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: The value of parameter _MVAR is impermissible.
61308 Channel %1 Block %2: Check measuring path _FA
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A traversing path for measuring was generated whose size was specified by parameter _FA that
describes the maximum distance before and after the switching position (workpiece edge) and that
must have a value greater than 0.
Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check parameter _FA.
61309 Channel %1 Block %2: Check probe type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Probe type: 3D probe inactive.
This alarm is generated by all cycles except for CYCLE971, CYCLE972, CYCLE982.
Remedy: The probe has to be of the "3D probe" type in the tool management.
Tool type of the workpiece probe in the TO memory is impermissible.
For CYCLE971: no permissible tool probe type entered in _TP[x,8], or check
the permissible working plane G17...G19 for tool type "Wheel".
61310 Channel %1 Block %2: Scale factor is active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Scale factor = scaling is active.
Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Switch off the active scale factor in the program. Measuring is not possible with an active scale factor.