Siemens SINUMERIK 840Di - Page 541

NCK alarms
11/2006 Overview of Alarms
2-541
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61339 Channel %1 Block %2:Correction factor for rapid traverse speed = 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check parameter _SPEED[0] in GUD6.
61340 Channel %1 Block %2: Incorrect alarm number
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Internal error in measuring cycles.
61341 Channel %1 block %2: Probe not calibrated in active plane.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE974, CYCLE977, CYCLE978, CYCLE979.
Remedy: Calibrate the probe prior to calling a cycle.
61342 Channel %1 Block %2: Invalid software version or wrong format entered
in GUD6
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Lower than measuring cycle software 6.2:_SI[1] in GUD6 has no value or a value < 3
Higher than measuring cycle software 6.3: Upgrade NCK software version.
61343 Channel %1 Block %2: No tool available for specified tool identifier
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check name of tool identifier.
61344 Channel %1 Block %2: Several tools are active
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Remove tool from another spindle.
61345 Channel %1 Block %2: Parameterized D number (_KNUM) too large
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Reduce the D number in _KNUM, check software or MD of flat D number.