Siemens SINUMERIK 880 Planning Guide

01.91 10 Data fields
10.2.3 PLC machine data bits
Bit 1 T=Locator number
"1" signal: Within the active magazine, a tool is addressed by the part program via its locator
number.
For any further chained magazines, the tool is searched for according to the
identification number (in preparation).
"0" signal: Within the active and all further chained magazines, a tool is addressed by the part
program via its
identification number.
Bit 0 Submagazine available
"1" signal: Magazine is taken into account by the tool selection, the neutral tool routine and
the search blocks during the search for an empty location.
"0" signal: The magazine is skipped by the search routines mentioned.
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1 10–25
SINUMERIK 840/880 (PJ)

Siemens SINUMERIK 880 Specifications

General

Brand	Siemens
Model	SINUMERIK 880
Category	Control Unit
Language	English