Panel cutout
The MCP 1900.2 is secured using 12 M5 nuts. The tightening torque is 1.5 Nm. In addition to the
M5 nuts, use the spring elements provided. Customers are responsible for the geometry of the
panel cutout, as well as mounting the MCP in the housing. To mechanically protect the outer
edge of the front panel, the device must be installed so that it is recessed by at least 0.5 mm with
respect to the surrounding housing.
Y
3[
① All corner radii <= R5 or chamfer <= 5x45°
*) In the seal area
Figure3-2 Panel cutout
Dimension drawings
ONE MCP Part 2: MCP 1900.2
16 Equipment Manual, 01/2023, A5E52559449B AA
To Next Page
Loading...
