10.3 Optimize MyProgramming /NX-Cam Editor
10.3.1 Setting up a connection to the CAM server
You must make the following adaptations to set up a connection to the CAM server.
Prerequisite
● You need administrator rights.
● A user must already be created in the NX CAM server.
Procedure
1. Open the file in the following directory:
<Installation directory>\SME\SinInt.SMEClient.Service\appsettings.production.json
2. Open entry "NxCamServer".
Supplement the corresponding data, such as
– end point and access data
– User name and password, e.g.:
{
"NxCamServer":{
"Endpoint":"http://***NXCAMSERVERURL:PORTNUMBER***",
"Username":"***user***",
"Password":"***pw***",
"Scope":"SME"
},
"ConsulEncryptFile":"<Installation directory>\\Consul\
\encrypt.json"
}
Additional information
The following description explains how you install and configure the NX CAM server: NX CAM
server documentation
Configuring applications
10.3 Optimize MyProgramming /NX-Cam Editor
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
Installation Manual, 12/2019, A5E44672080B AE 187
To Next Page
Loading...
Need help?
General
