Panel cutout
The MCP 2400.4c is secured using 10 M5 nuts. The tightening torque is 1.5 Nm. In addition to
the M5 nuts, use the spring elements provided. Customers are responsible for the geometry of
the panel cutout, selecting the seal, as well as fastening the MCP in the housing. To mechanically
protect the outer edge of the front cover, the device must be installed so that it is recessed by at
least 0.5 mm with respect to the surrounding housing.
[
5]
*) In the sealing area
Figure 3-2 Panel cutout for the MCP 2400.4c (all dimensions in mm)
Dimension drawings
ONE MCP Part 2: MCP 2400.4c
16 Equipment Manual, 06/2022, A5E52072312B AA
To Next Page
Loading...
