Siemens siprotec 7SD5 - Page 4

Preview
4
SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
PROFIBUS-DP
specification
The PROFIBUS-DP specification and the structure of the PROFIBUS-DP messages
are defined in the European Standard EN 50170:
 PROFIBUS Specification
Normative Parts of PROFIBUS-FMS, -DP, -PA
According to the European Standard
EN 50170, Volume 2
PROFIBUS Nutzerorganisation e.V.
Validity This manual is valid for the SIPROTEC devices:
• 6MD63 (firmware version 4.40 or higher),
• 6MD663/6MD664 (firmware version 4.20 or higher),
• 7SA522, 7SA6 (firmware version 4.20 or higher),
• 7SD5, 7SD610 (firmware version 4.20 or higher),
• 7SJ61...7SJ64 (firmware version 4.40 or higher),
• 7ST61, 7ST63 (firmware version 4.00 or higher),
• 7ST622 (firmware version 4.00 or higher),
• 7UM61 (firmware version 4.10 or higher),
• 7UM62 (firmware version 4.00 or higher),
• 7UT612 (firmware version 4.00 or higher),
• 7UT613, 7UT63 (firmware version 4.00 or higher),
• 7VE61, 7VE63 (firmware version 4.00 or higher),
• 7VK61 (firmware version 4.00 or higher),
with PROFIBUS communication module up to HW revision 3 and
• PROFIBUS-DP firmware version 02.00.05,
• PROFIBUS-DP firmware version 03.00.03 or higher at use of
• Transformer tap change commands/Transformer tap position indications
(ref. to chap 3.7 and 3.8),
• Event list via PROFIBUS-DP (Sequence of events, ref. to chap. 2.5),
• PROFIBUS-DP firmware version 03.01.03 or higher at use of
• Time synchronization via PROFIBUS-DP with time intervals between time
synchronization messages of less than 1 minute (ref. to chap. 4.4),
• PROFIBUS-DP firmware version 03.04.01 or higher at use of
• PROFIBUS time synchronization messages with local time correction value
(ref. to chap. 4.4.2),