SIREMOBIL Compact Register 3 RXR2-130.033.04 Page 4 of 4 Siemens AG
Rev. 01 08.96 TD SP 1 Medical Engineering
4 Installing and setting the Video Recorder
For Memoskop C-E (without keyboard) 1
• Switch on the system.
• On Memoskop C-E, the keyboard connector includes an adapter.
• Connect the Service PC to the adapter on Memoskop C-E and start Windows.
• Call up the "terminal.exe" program.
• Set the following in the "terminal.exe" program:
• Adjust to the interface being used (COM1 / COM2).
• The keyboard is now emulated with the service PC.
• Simultaneously press the [CTRL] and [U] keys on the service PC.
➪ This calls the User Setup menu for Memoskop.
• Call up the "B output for video recorder" submenu.
• Perform the configuration for monitor A.
(Perform the configuration for monitor B only by special customer request.)
• End the User menu.
• Switch the SIREMOBIL Compact off and on again to activate the new configuration.
Function check 1
• Set the video recorder to exposure.
• WIth Fluoro, move the collimator blades slightly into the field.
Release fluoro for approximately 20 seconds.
• Stop the video recorder and rewind the tape.
• Connect a 50 Hz / 60 Hz monitor to the video output of the video recorder and replay the
scene.
Concluding work 1
• Switch OFF the SIREMOBIL .
• Test the protective conductor with the protective conductor meter 44 15 899 RV 090 .
Refer also to TI 236 / ARTD - 002.731.17...
9600 Baud 8 Bit Parity none 1 Stopbit
The service PC keyboard does not include the >|< (Home) key.
Instead, in the main User Setup menu enter the letter "O". Enter
the next unused number in the sub-menu of the User Setup.
Example: The last sub-menu is called up by entering the number
12. -> The >|< (Home) key would be emulated by entering the num-
ber 13.
TD SP 2 / Arnold TD SP 1 / Schlee SMS Iselin / O’Donnell
To Previous Page
Loading...
