To Next PageTo Next PageHow to check the input selection switch on Siemens Monitor?
Inspect the input selection switch located at the bottom of the TFT display. It has three positions: 1. Rear position: VGA input is selected. 2. Middle position: BNC input is selected, with the 75 Ohm termination resistor off. 3. Front position: BNC input is selected, with the 75 Ohm termination resistor on.
How to compare display values on Siemens Monitor?
Scroll to the "Mode Info" menu and select it by pressing the "Enter" key. Compare the displayed values with the values in the table Tab. 1.
General| Type | Mobile C-arm X-ray system |
|---|---|
| X-ray Generator | High-frequency generator |
| Generator Power | 2.5 kW |
| Voltage Range | 40 - 110 kV |
| Image Intensifier | 9-inch image intensifier |
| Focal Spot Size | 0.6 mm |
| Power Supply | 230 V, 50/60 Hz |
| Applications | Orthopedics |
| C-arm SID | 1000 mm |
Lists all tools and devices needed for service and calibration.
Provides critical safety warnings for performing service.
Warns about electrical hazards and necessary precautions.
Warns about radiation hazards and protection measures.
Procedure to check and adjust low voltages against specified values.
Procedure to check and adjust Image Intensifier voltages.
Procedure for adjusting the kV offset of the generator.
Procedure for adjusting the generator using a learning program.
Steps to verify the generator's performance using an oscilloscope.
Procedure to adjust the dose rate levels for different formats and modes.
Steps to set the dose rate for the survey format.
Steps to set the dose rate for the zoom format.
Procedure to set the maximum permissible skin dose rate.
Procedure to adjust the X-Iris collimator.
Procedure to calibrate the area dose product measurement device.
Procedure for replacing the SIREPHOS component.
Procedure for replacing the MULTISPOT 2000.
Procedure for replacing the area dose product measurement device.
Procedure for measuring tube current and calculating it using a formula.
