SIREMOBIL Compact SPR2-130.061.02 Page 22 of 30 Siemens AG
System Manual Rev. 11 09.04 CS PS 24 Medical Solutions
5 - 22 Adjustments / Programs
• Switch the SIREMOBIL Compact OFF and ON again.
• Check the adjustments again. In the 0° position, the object image must correspond to the
one in Fig. 3.
Calibrating the area dose product measurement device 5
Calculating the CONSTANT parameter (Qt * Kg) 5
• Read and record the Kg value shown on the electronics unit of the area dose product
measurement device.
• Read the Qt value on the dose chamber of the area dose product measurement device.
• Multiply these values and record them. The resulting value is the CONSTANT (QT*Kg)
value to be programmed.
Programming 5
• Connect the service PC to the serial interface on board D1.
• Start the service program.
• Select the Adjustment, Parameter menu.
• In the Combo box "Parameter Groups", select "Diamentor".
• Click on "Get from Unit".
• The Parameter "1. Diamentor Existing" must be on YES .
• Select parameter "2. Constant (Qt * Kg)".
• In "Value Actual:" field, enter the parameter you have calculated.
• Click on "Set Value".
• Click on "Put to Unit" .
• Click on "Save to File".
Checking the programmed values 5
Prerequisites
The Qt * Kg value was checked and is programmed. Refer to Programming.
• Connect the service PC to the serial interface on board D1.
This adjustment is used to calibrate the area dose product mea-
surement device of the SIREMOBIL Compact display.
You must exit the service program with "Logoff" and "Quit" to
store the modified parameters to disk as a new file.
Checking the programmed values will activate the self-test in the
electronic system of the area dose product measurement device.
This serves to recalibrate the electronic system of the area dose
measurement device.
NOTE
NOTE
NOTE
To Next Page
Loading...
