Adjustments / Programs 5 - 29
Siemens AG SPR2-130.061.02 Page 29 of 30 SIREMOBIL Compact
Medical Solutions Rev. 11 09.04 CS PS 24 System Manual
Configuring the MEMOSKOP 5
MEMOSKOP C-E, keyboard emulation 5
There is no keyboard supplied with some SIREMOBIL Compact units and installed
MEMOSKOP C-E. When replacing the MEMOSKOP C-E or when changing the configu-
ration, the MEMOSKOP service program should be used.
The help file "C-DATA.hlp" will be copied to the service PC during installation of the
MEMOSKOP service program. The "C-DATA.hlp" help file contains descriptions of the
programming.
Configuring the video frequency 5
After replacing the MEMOSKOP, it will start at a default video frequency (50 Hz). If the
monitors were configured for a different frequency, you will have to configure the correct
video frequency without a "visible image".
With out installed MEMOSKOP keyboard:
• Use the MEMOSKOP service program to modify the configuration.
With installed keyboard proceed with the steps described below:
• Invoke Technical Setup on Memoskop (press the CTRL + T keys.)
• Press the "2" key and press return. The video frequency menu is selected.
• Depending on the required video frequency, press the right cursor key "->".
"->" = Press the right cursor key
"<-" = Press the left cursor key.
Roadmap K-factor, phase B Noise suppression, phase B, is programmed in the road-
map mode.
Phase B: Acquisition of fill images.
Roadmap K-factor, phase C Noise suppression, phase C, is programmed in the road-
map mode.
Phase C: Acquisition of roadmap images.
Roadmap Time of phase A The time of phase A in the roadmap mode is programmed.
Phase A: Mask acquisition.
"->" pressed 1 time: 60 Hz video frequency
"->" pressed 2 times: 100 Hz video frequency
"->" pressed 3 times: 120 Hz video frequency
"->" pressed 4 times: 50 Hz video frequency.
Function: Comments:
To Next Page
Loading...
