English
3ZX1012-0RW44-1AA1 19
Phase voltages
UL1N
UL2N
UL3N
Phase-to-phase voltages
UL1-L2
UL2-L3
UL3-L1
Blocking voltages
ULT1
ULT2
ULT3
Phase currents
IL1
IL2
IL3
Power
Line frequency
Supply voltage
Heatsink temperature
Motor heat build-up
Remaining time for tripping
Switch off standard display
Device status
Active parameter set
Parameter set 1
Parameter set 2
Parameter set 3
Type of connection
Unknown/faulty
Star/delta
Inside delta
Direction of rotation
Unknown
Clockwise
Counter-clockwise
Inputs
Status - Inputs
Input 1 - Action
No Action
Manual operation local
Emergency start *
Slow speed
Quick stop *
Trip reset
Motor right PS1
Motor left PS1 **
Motor right PS2
Motor left PS2 **
Input 2 - Action [...]
Input 3 - Action [...]
Input 4 - Action [...]
Outputs
Status - Outputs
Output 1 - Action
No Action
Run up
Bypass operation
Coasting down
On time motor
PIO output 1
PIO output 2
Command motor-on
DC braking contactor
Output 2 - Action [...]
Output 3 - Action [...]
Order number
Firmware information
Version
Date
Display measured value Status display
Settings
Parameter set 1
Motor 1
Rated operating current Ie
Rated operating torque
Rated operating speed
Copy motor data to PS2 + 3
Starting settings
Starting mode
Voltage ramp
Voltage ramp + current limiting
Torque control
Torque control + current limiting
Start voltage
Start torque
Limiting torque
Starting time
Maximum starting time
Current limiting value
Breakaway voltage
Breakaway time
Motor thermal capacity *
Stopping settings
Stopping mode
Coasting down
Torque control
Stopping time
braking torque
Slow speed- parameters
Slow speed factor right
Slow torque right
Slow speed factor left
Slow torque left
Parameter set 2 [...]
Parameter set 3 [...]
Inputs
Input 1 - Action
No Action
Input 2 - Action [...]
Input 3 - Action [...]
Input 4 - Action [...]
Outputs
Output 1 - Action
No action
Motor protection
Tripping class
None
CLASS 5 (10a)
CLASS 10
CLASS 15
CLASS 20
CLASS 30
Current asymmetry limit value
Prewarning limit tripping reserve
Prewarning limit motor heat build-up
Idle time
Protection against voltage failure
No
Yes
Temperature sensor
Deactivated
Thermo click
PTC type A
Display settings
Language
English
Deutsch
Français
Español
Italiano
Português
Contrast
Lighting
Brightness
Lighting on
Off with time delay
Lighting off
Response to fault
Unchanged
On
Blinking
Flickering
Response to warning
Unchanged
On
Blinking
Flickering
Reaction time keys
Auto repeat
Time
Speed
Activity monitoring time
Response to...
Overload - therm. motor model
Tripping without restart
Tripping with restart
Warning
Overload - temperature sensor
Tripping without restart
Tripping with restart
Warning
Current limit value violation
Warning
Tripping
Overload - contact block
Tripping without restart
Tripping with restart
Asymmetrie
Warning
Tripping
Earth fault
Warning
Tripping
Name
Name
Saving options
Save settings
Restore settings
Restore basic factory settings
OK
3RW44 Menu structure
Motor right PS3
Motor left PS3 **
Input 1
Input 2
Input 3
Input 4
Group warning
Group error
Bus error
Device error
Power on
Ready to start
Output 4 - Action [...]
Direct on line
Motor heating *
Pump stop
DC braking
Combined braking
Stopping torque
Dynamic braking torque
DC
Current limit values
Minimum current limit
Maximum current limit
Manual operation local
Emergency start *
Slow speed
Quick stop *
Trip reset
Motor right PS1
Motor left PS1 **
Motor right PS2
Motor left PS2 **
Motor right PS3
Motor left PS3 **
PIO-output 1
PIO-output 2
Input 1
Input 2
Input 3
Input 4
Run up
Bypass operation
Coasting down
On time motor
Command motor-on
DC braking contactor
Group warning
Group error
ESC
Bus error
Device error
Power on
Ready to start
OKESC OKESC
Pre-charge time
Output 2 - Action [...]
Output 3 - Action [...]
* Delivery version 2
** Possible only in connection with creep speed
To Next Page
Loading...
