Preface
SIRIUS Soft Starter 3RW44 PCS 7 Library V8.2
8 Getting Started, 07/2016, A5E36563533002A/RS-AA/001
Software required for the Getting Started of the PCS 7 block library for Soft Starters
● You can execute the example project on any PC or programming device on which the
following software is installed:
– Windows operating system
– Internet Explorer
– Message Queuing service
– SQL server
Note
The versions required depend on the version of PCS 7 installed.
You can find further relevant details in the following manuals:
– SIMATIC Process Control System PCS 7 PC Configuration and Authorization (V8.0)
on the Internet (https://support.industry.siemens.com/cs/document/68157327/
).
– SIMATIC Process Control System PCS 7 Released Modules (V8.0) on the Internet
(https://support.industry.siemens.com/cs/document/109736547/
).
● You create the PCS 7 project with SIMATIC Manager.
To do so, follow the instructions in the Process Control System PCS 7; Getting Started
documentation.
Hardware required for creating an example project
Table 1- 1 Soft Starter hardware
3RW4422-1BC44 SIRIUS Soft Starter, values with 400 V, 40 DEG., Standard: 29 A, 15 KW, inside-delta
circuit: 50 A, 22 KW, 200 … 460 V AC, 230 V AC, screw terminals
3RW4900-0KC00 Communication board PROFIBUS for SIRIUS Soft Starter 3RW44
Note on the firmware version
If the Soft Starter is operated as a DP slave following a Y link with a firmware version
<=*E03*, no DPV1 functionality is available. Firmware version >=*E04* is required for
DPV1 functionality following a Y link.
To Next Page
Loading...
