Siemens SITRANS L 7ML1100 - Mounting; Solids applications

Installing/mounting
3.4 Mounting
Transducers
Compact Operating Instructions, 09/2021, A5E43390688-AC
21
3.4 Mounting
Note
•
The transducer is to be used only in the manner outlined in this operating instructions.
•
Normally, the transducer requires no cleaning or maintenance. However, if performance
changes are observed, immediately shut down the level measurement system and
perform a thorough inspection, especially on the transducer.
•
An XPS-15F transducer is shown in these examples. An explosion proof conduit seal may
not be required.
3.4.1 Solids applications
XPS-15F,
XRS-5C
XPS-10, XPS-15,
XPS-30, XRS-5
ST-H
①
Easy aimer (typical model)
②
Safety chain
③
Transducer