To Next PageTo Next Page
Need help?Do you have a question about the Siemens SITRANS LT500 and is the answer not in the manual?
General| Device Type | Level Transmitter |
|---|---|
| Measurement Principle | Ultrasonic |
| Output Signal | 4-20 mA, HART |
| Power Supply | 12 to 36 V DC |
| Process Temperature | -40 to +85 °C (-40 to +185 °F) |
| Process Pressure | Up to 3 bar (43.5 psi) |
| Enclosure Rating | IP66/IP67, Type 4X |
| Communication | HART |
| Material | Stainless steel |
| Application | Level, volume and flow measurement in a wide range of industries and applications |
Emphasizes observing instructions and symbols on the device for safe operation and maintenance.
Details qualifications required for personnel and safety precautions when operating in hazardous environments.
Provides general installation guidelines, requirements, and things to avoid for proper setup.
Illustrates the overall connection scheme and identifies various connection points and devices.
Details safety warnings regarding improper power supply in hazardous areas.
Highlights dangers of toxic gases, hazardous voltage, and improper commissioning in hazardous areas.
Describes the device's HMI for quick commissioning using local buttons and display.
Guides through the initial power-on process, including language, date/time, and quick commissioning wizard.
Explains the process of using quick start wizards to configure the device for various applications.
Stresses periodic inspection and precautions against moisture penetration during work.
States that repairs must be by authorized personnel and warns about hazardous voltage when open.
