Commissioning
6.5 Local commissioning
SITRANS LT500 with ultrasonic transducer inputs
Compact Operating Instructions, 02/2024, A5E52021877-AA
59
Length units
Sets the length units applied for local operation and the communication interface, on
measurement point 1 and 2.
• m (meters)
• cm (centimeters)
• mm (millimeters)
• ft (feet)
• in (inches)
Process value too large to display
In some cases, it is possible that the process value is too large to show on the local display,
"
#####" will show instead.
If this occurs in a typical application:
Adjust parameter "Units" so that a smaller value can be shown, e.g. use meters instead of
millimeters.
If this occurs in a custom application:
Adjust parameter "Custom units" so that a smaller value can be shown, e.g. use tons
instead of pounds.
Note that a change to custom units also requires a manual scaling adjustment.
To Next Page
Loading...
