Siemens SITRANS TH Series - Page 10

SITRANS TH/TR/TF
10 A5E32520693-01, 06/2013
3.2
Mounting SITRANS TF
①
Cover with inspection window
⑥
Plug-in connector from SITRANS TH200 or TH300
②
Display module (digital display)
⑦
Ex nameplate
③
Cable gland for auxiliary power
supply/analog output
⑧
M4 screw
④
SITRANS TF field housing
⑨
Cable gland for sensor cable
⑤
Spacers
Figure 3-3 Design of SITRANS TF with display module (digital display)
Procedure
1. Unscrew the front cover ①.
2. Screw the two spacers
⑤ into the right and left threads. Torque approx. 3 Nm.
3. Remove the left-hand shorting bars on the PC board located under the transmitter.
4. Insert the plug-in connector from the display module. The plus side with the red wire must face upward.