What to do if Siemens Transmitter current signal is greater than 22 mA or less than 3.6 mA?
If the current signal from your Siemens Transmitter is greater than 22 mA or less than 3.6 mA, it indicates a defect in the transmitter electronics. Depending on the device version, replace the device or send it in for repair.
Why is the 4 … 20 mA signal missing on my Siemens SITRANS LR110 Transmitter?
A missing 4 … 20 mA signal on your Siemens Transmitter can be due to several reasons: * A faulty electrical connection. Check the connection and correct it if necessary. * Missing voltage supply. Inspect cables for breaks and repair if needed. * Operating voltage being too low or load resistance being too high. Check and adapt as necessary.
Why does the measure value jump sporadically towards 100 % during filling with my Siemens SITRANS LR110?
If the measured value jumps sporadically towards 100 % during filling, it is caused by changing condensation or contamination on the antenna. To solve this, carry out auto false echo suppression or increase auto false echo suppression in the close range by editing.
What to do if there is a general software error on Siemens Transmitter?
If you encounter a general software error on your Siemens Transmitter, restart the transmitter.
How to fix error in the electronics of Siemens SITRANS LR110 Transmitter?
If there is an error in the electronics of your Siemens Transmitter due to a limit value being exceeded in signal processing or a hardware error, restart the transmitter. If the issue persists, send the transmitter for repair.
How to resolve error in the linearization table of Siemens Transmitter?
To resolve an error in the linearization table of your Siemens Transmitter, check the linearization table. If index markers are not continuously rising or there are illogical value pairs, delete the table and create a new one.
What to do if Siemens SITRANS LR110 Transmitter adjustment span is too small?
If the adjustment span on your Siemens Transmitter is too small because the adjustment is not within specification, change the adjustment according to the limit values, ensuring the difference between minimum and maximum is at least 10 mm.
How to fix unstable 4 … 20 mA signal on Siemens SITRANS LR110 Transmitter?
If the 4 … 20 mA signal on your Siemens Transmitter is unstable due to a fluctuating measured value, set damping.
What to do if Siemens SITRANS LR110 has no operable software?
If your Siemens Transmitter has no operable software due to a checksum error from a failed or aborted software update, repeat the software update. If the issue continues, send the transmitter for repair.
Emphasizes that all operations must be performed by trained and authorized personnel.
Covers general safety requirements, regulations, and directives for safe operation.
Describes methods for wireless and signal cable adjustment of the transmitter.
Provides detailed guidance on installation position, reference points, and nozzle mounting.
Shows the wire assignment for the permanently connected cable.
Provides guidance on identifying and rectifying common malfunctions and errors.
Explains status messages and pictographs for device self-monitoring and diagnostics.
Offers solutions for typical application-related measurement errors and their causes.
Presents comprehensive technical specifications, including electrical and performance data.
General| Brand | Siemens |
|---|---|
| Model | SITRANS LR110 |
| Category | Transmitter |
| Language | English |
To Next Page