Siemens SITRANS TH100Slim - Set the Linearization Table (60 Breakpoints); Set the Spline Curve (40 Breakpoints); Sensor Calibration; Introduction

Procedure
1. Navigate to the parameter view.
Navigating in the views (Page 110)
2. Select the parameter "User PIN".
3. Use the
button to con󹪝rm.
4. Select YES with the or button.
5. Use the button to con󹪝rm.
The message "USER PIN OFF" appears for 2 seconds.
Result
The User PIN is disabled.
9.3.18 Minimum measured peak value at Input 1 [19]
Shows the minimum measured peak value at input 1.
Indication on the dis‐
play
MIN INPUT 1
9.3.19 Maximum measured peak value at Input 1 [20]
Shows the maximum measured peak value at input 1.
Indication on the dis‐
play
MAX INPUT 1
Parameter assignment
9.3 Parameter assignment over device with display
SITRANS TH100/TH100Slim/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
162 Operating Instructions, 07/2021, A5E41864807-AD