71
Gigaset SL400/400 A / IM-MEA EN / A31008-M2103-A601-1-UZ19 / registr_sett.fm / 11.05.2010
Version 4, 16.09.2005
Activating/deactivating
music on hold
v ¢
Ï
¢ Audio Settings
¢ Music on Hold
Press §Change§ to activate or deactivate the
music on hold (³ = on).
Activating repeater
support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
v
¢
Ï
¢ System ¢ Repeater Mode
Press §Change§ to activate/deactivate repeater
mode (³ = activated).
Switch your handset off and on again
(
¢ page 22), once the repeater has
been activated/deactivated.
Protecting against
unauthorised access
Protect the base system settings with a PIN
known only to you. The system PIN must be
entered when, for example, registering/
deregistering a handset to/from the base or
when restoring the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only to you.
Gigaset SL400A: Setting a system PIN facili-
tates remote operation of the answering
machine (
¢ page 51).
v ¢
Ï
¢ System ¢ System PIN
~ Enter the current system PIN
and press
§OK§.
~ Enter your new system PIN and
press
§OK§.
Resetting the system PIN
If you have forgotten your system PIN, you
can reset the base to the original code 0000:
Disconnect the power cable from the base.
Hold down the registration/paging key on
the base while reconnecting the power
cable to the base. Hold down the key for at
least 5 seconds.
The base has now been reset and the system
PIN is set to 0000.
Resetting the base to the
default settings
When the settings are restored:
u Date and time are retained
u Handsets are still registered
u Eco Mode is activated and Eco Mode+ is
deactivated,
u The system PIN is not reset.
v ¢
Ï
¢ System ¢ Base Reset
~ Enter the system PIN and
press
§OK§.
§Yes§ Press the display key.
Please note
u Eco Mode / Eco Mode+ (¢page 54)
and repeater support cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or Eco
Mode+.
u The default encrypted transmission
setting is deactivated when a
repeater is activated.
Please note
All handsets are deregistered and must
be re-registered. All settings are reset to
the default settings.
To Next Page