Siemens SL75 - Getting Started; Inserting SIM Card; Battery

Getting started10
© Siemens AG 2003, C:\Siemens\DTP-Satz\Produkte\SL75_Hydra_1\out-
left page (10) of SL75 Hydra FUG, w/o ptt, en, A31008-H3300-A1-1-7619 (15.09.2005, 11:47)
Template: X75, Version 2.2;VAR Language: en; VAR issue date: 050822
Getting started
Your phone's display is covered with
a protective film. Remove this before
using the phone.
Inserting SIM card/
battery
The service provider supplies you
with a SIM card on which all the im-
portant data for your line is stored. If
the SIM card has been delivered in
credit-card size, snap the smaller
segment out and remove any rough
edges.
• Place the SIM card in front of the
slot with the contacts facing
downwards. Then push the SIM
card fully into the holder using
gentle pressure
1. Ensure that
the chamfered corner is in the
correct position.
• Insert the battery into the phone
with the retaining lugs beneath
the camera lens
2 and then press
down
3 until it clicks into place.
• To remove, press the catch
down
4
until the battery springs
out a little, and then remove
5
.
In rare cases static
discharge can
cause temporary
discoloration in
the display.
However, this
will disappear
within approx.
10 minutes.
1
3
2
5
4