EasyManua.ls Logo

Siemens ST60 - Special Characters

Siemens ST60
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Text entry
22
ST60 english retail, A31008-H6855-A101-1-7619 (11. December 2003,
© Siemens AG 2001, I:\Mobil\ST60\retail\en\_von_itl\ST60_Retail_EN_031209\ST60_text.fm
Special characters
*
Hold down. The symbols
chart is displayed (p. 20).
F
I
Navigate to the required
symbol.
§Select§ Press or confirm choice by
clicking on the joystick.
Correct a word
F Move character by charac-
ter to the left/right.
§Clear§ Deletes the character to
the left of the cursor.
T9 word suggestions
If several options are found in the
dictionary for a key sequence (a
word), the most probable is dis-
played first. If the word you want has
not been recognised, the next sug-
gestion from T9 may be correct.
The word must be §highlighted§. Then
press
again. The displayed word
is replaced with a different
word. If this word is also
incorrect, press
again. Repeat until the cor-
rect word is displayed. If
the word is not in the dic-
tionary, write it without T9
or add it to the dictionary.
To activate:
(Spell) Select.
The last suggestion is deleted and
the word may now be entered with-
out T9 support. Press §Save§ to add it
automatically to the dictionary.
Additional information
0
Set a full stop. A word is con-
cluded if it is followed by a
space. Within a word, a full
stop represents an apostrophe
or hyphen:
e.g. §provider.s§ = provider’s.
E
Go to the right: ends a word.
Additional information
Within a "T9 word", individual letters may
not be edited without first removing the T9
status. In most cases it is better to rewrite
the complete word.

Table of Contents

Related product manuals