Getting started
9
ST60 english retail, A31008-H6855-A101-1-7619 (11. December 2003,
© Siemens AG 2001, I:\Mobil\ST60\retail\en\_von_itl\ST60_Retail_EN_031209\ST60_startup.fm
Charge battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone
1,
plug the charger cable into a mains
power socket and charge for at least
2.5 hours.
To remove, push the buttons on the
side of the connector in the direction
of the arrows
2.
Charging time
An empty battery is fully charged
after about 2.5 hours. Charging is
only possible within a temperature
range of +5 °C to +40 °C. The mains
voltage specified on the power sup-
ply unit must not be exceeded.
Charge icon not visible
If the battery has been discharged
fully the charge icon is not immedi-
ately visible when the charger is
plugged in. It will appear after up to
2 hours. In this case the battery is
fully charged after 3-4 hours.
Please only use the power supply unit
provided!
Display while in service
Charge level display during opera-
tion (empty – full):
A beep sounds when the battery is
nearly empty. The charge level of the
battery is only displayed correctly
after an uninterrupted charging/dis-
charging cycle. You should therefore
not remove the battery unnecessarily
and where possible not finish the load-
ing process early.
Operating time
A full battery will deliver up to
140 hours of standby time or
270 minutes of talktime (p. 78).
2
1
2
Additional information
The charger heats up when used for long
periods. This is normal and not dangerous.
To Next Page
Loading...
