Siemens syngo MR XA30 - Performing the measurement

2 Position the first Contour 24 coil on the patient and connect the
coil to coil socket 1.
3 Attach the Velcro adapter strap to the Velcro pads along the edge
of the first Contour 24 coil. The Velcro pads are on the reverse side
of the cable outlet. Ensure that the strap is attached to all three
Velcro pads.
4 Position the second Contour 24 coil so that it overlaps the first
coil, with the Velcro pads positioned directly over the Velcro
adapter strap.
For a better balance of the coil combination on the patient, you
should position the two coils with their boxes (cable outlets) on
opposite sides.
5 Connect the second coil to coil socket 2.
6 You can also use the coil combination with the cable outlets
pointing to the head and feet. This positioning may be useful for
larger patients.
If necessary, adjust the position of the coil combination according
to your needs.
7 If necessary, use standard positioning accessories to secure the
coil combination. For example, use straps.
Performing the measurement
1 Align the laser-light localizer with the center of the region of
interest.
2 Start the measurement.
4.4
Use 4
MAGNETOM Family | syngo MR XA30
Print No. MR-06032G.640.01.02.02
17