Siemens TC35i - Commands from Change Requests TC;AC;MC35; New Features for Tc35 I Only - Misc; Siemens Defined at Commands for Enhanced Functions; List of Unsupported AT-Commands

TC35i: Migration from TC35 to TC35i
PRELIMINARY
TC35_TC35i_MIG_01_V01.01 29.1.2003 Page 33 of 34
# AT Command
8 AT+CIND Indicator Control
5.3.3 Commands from change requests TC/AC/MC35
Table 5-8: AT commands from change requests
# AT Command
9 AT^SRTC Select, query and test ringing tones
5.3.4 New features for TC35i only – misc.
Table 5-9: New TC35i features
# AT Command
10 AT\V Configure CONNECT Response
11 AT^SAIC Audio Interface Configuration
12 AT^SMOND Monitoring
13 AT^SSR SIM READY
14 AT%D Automatic dial on DTR line activation
15 AT+ICF Set TE-TA control character framing
16 AT+IFC Set TE-TA local data flow control
17 AT+CMMS More Messages to Send
5.3.5 Siemens defined AT commands for enhanced functions
Table 5-10: New Siemens defined AT commands
# AT Command
18 AT^SNFA Set or query of microphone attenuation
19 AT^SLMS List Memory Storage
20 AT^SBV Battery Voltage
21 AT^SPBD Delete the given Phonebook
5.4 List of unsupported AT-Commands
TC35i supports the entire TC35 AT command set.
5.5 List of AT-Commands for V.25ter compatibility
These commands return "OK" but have no functionality in both TC35i and TC35.
Table 5-11: V.254ter compatibility commands
# AT Command
1 ATL Set monitor speaker loudness
2 ATM Set monitor speaker mode
3 ATP Select pulse dialling
4 ATS2* Escape code sequence
5 ATS6 Set pause before blind dialling
6 ATS8 Set number of seconds to wait for comma dial modifier
7 ATT Select tone dialling