Siemens TE515 Series - Before First Use

26
en Before using for the rst time
Before using for
the rst time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use co󰀨ee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see “Menu settings”
Water hardness).
Switching on the appliance
■ Remove the protective lm.
■ Place the fully automatic espresso
machine on a at, waterresistant surface
that can take its weight. Make sure that
the machine’s ventilation slots remain
unobstructured.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
■ Pull the power cord out of the storage com-
partment (21) and plug in. Adjust the length
of the cable by pushing it back in or pulling
it out. The easiest way to do this is to place
the appliance so that its back is ush with
the edge of the counter and either pull the
cable downward or push it upward.
■ Install the milk frother. Operate the
machine only after the milk frother (6) has
been fully assembled and installed.
■ Lift the lid of the water tank (18).
■ Remove and rinse the water tank (17)
and ll it with fresh cold water.
Do not ll above the max mark.
■ Replace the water tank (17) and push it
rmly downward into place.
■ Close the lid of the water tank (18) again.
■ Fill the bean container (1) with co󰀨ee
beans (for preparation using ground
co󰀨ee, see “Preparation using
ground co󰀨ee”).
■ Press the power switch O / I (9). The
display (16) shows the menu for setting
the display language.
■ Select the required display language with
the upper rotary knob (15).
■ Place a receptacle under outlet (6a).
■ Press the start button (10).
The language you selected is saved.
The appliance heats up and rinses. Some
water will run out of the co󰀨ee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
Switching o󰀨 the appliance
The factory settings of the fully automatic
espresso machine are programmed for
optimal performance. The appliance
switches o󰀨 automatically after a specic
time (time span can be programmed, see
“Menu settings” Shut off).
Exception: The appliance switches o󰀨
without rinsing if only hot water or steam
were dispensed.