36
en Frost protection
Fill descaler
Press start
■ Pour lukewarm water into the empty
water tank (17) up to the 0.5 l mark and
then dissolve 1 Siemens descaling tablet
TZ80002 in it.
■ Press the start button (10).
Place container
Press start
■ Place a receptacle with a capacity of at
least 1 litre under the outlet (6a).
■ Press the start button (10).
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 22 minutes.
Clean / Fill water tank
Press start
■ Rinse the water tank (17) and rell it with
fresh water up to the max mark.
■ Press the start button (10).
Calc‘n‘Clean in progress
The descaling pro gramme now runs for
about 10 minutes and rinses the appliance.
Empty drip tray
Insert drip tray
■ Empty drip tray (8) and replace them.
Replace the lter if one is being used. The
appliance has nished cleaning is ready for
use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust lm
on stainless steel and must therefore be
washed out thoroughly before use.
Frost protection
W To avoid damage from low
temperatures during transport and
storage, the appliance must be
completely emptied rst.
Note: The appliance must be ready for use
and the water tank (17) lled.
■ Place a large receptacle under outlet (6a).
■ Press the l / m button (12) and
allow the appliance to steam for about
15 seconds.
■ Switch the appliance o at the power on/
o switch O / I (9).
■ Empty the water tank (17) and the
drip tray (8).
Accessories
The following accessories can be obtained
from retailers and customer service.
Accessories Ordering number
Retail /
Customer service
Cleaning tablets TZ80001 / 00311807
Descaling tablets TZ80002 / 00576693
Water lter TZ70003 / 00575491
Care set TZ80004 / 00576330
Milk container with
“Fresh Lock” lid
TZ80009N / 00576166
To Next Page
Loading...
