Siemens TE515 Series - Page 38

34
en Service Programmes
Never put descaling tablets or other
descaling agents in the ground co󰀨ee
drawer or the drawer for cleaning tablets (4)!
Before starting the service programme
(Descale, Clean or Calc’nClean), remove
the brewing unit, clean as instructed and
re-insert.
Specially developed descaling and
cleaning tablets are available from
retailers or customer service (see
“Accessories”).
Descaling
Duration: approx. 25 minutes.
Important: If there is a lter in the water
tank (17), it needs to be removed before the
descaling programme is run.
If the message Descale required! appears
on the display, press the k o󰀨 / i button
(13) for 3 seconds and then press the start
button (10). The descaling programme
will start. To descale the appliance before
being prompted, press the k o󰀨 / i button
(13) for at least 3 seconds. Then press the
k o󰀨 / i button (13) briey twice. Turn the
upper rotary knob (15) until Start descaling
appears in the display. To start the descal-
ing procedure, press the start button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
■ Empty drip tray (8) and replace them.
N.B.: If the water lter is activated, the
display will prompt you to remove the lter
and then press the start button (10) again.
Remove the lter now if you have not
already done so. Press the start button (10).
Fill descaler
Press start
■ Pour lukewarm water into the empty
water tank (17) up to the 0.5 l mark and
then dissolve 1 Siemens descaling tablet
TZ80002 in it.
■ Press the start button (10).
Place container
Press start
■ Place a receptacle with a capacity of at
least 0.5 litres under the outlet (6a).
■ Press the start button (10).
Descale in progress
The descaling pro gramme will now run for
about 20 minutes.
Clean / Fill water tank
Press start
■ Rinse the water tank (17) and rell it with
fresh water up to the max mark.
■ Press the start button (10).
Descale in progress
The descaling pro gramme now runs for
about 3 minutes and rinses the appliance.
Empty drip tray
Insert drip tray
■ Empty drip tray (8) and replace them.
Replace the lter if one is being used. The
appliance has completed descaling and is
ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust lm
on stainless steel and must therefore be
washed out thoroughly before use.