Siemens TE515 Series - Page 43

39
en
Simple troubleshooting
Problem Cause Solution
Restore the unit to its
original factory settings
(“Reset”).
You changed some
settings and want to
discard them.
Turn o󰀨 the unit with the power
on/o󰀨 switch O / I (9). Press and
hold the k o󰀨 / i (13) and the l
(12) button and turn the appliance
on with the power on/o󰀨 switch
O / I (9). Conrm by pressing the
start button start (10). The factory
settings are now activated.
Display shows
Refill beans! although the
bean container (1) is full,
or the grinding unit does
not grind the beans.
Beans are not falling into
the grinding unit
(beans too oily).
Gently tap the bean container (1).
Change the type of co󰀨ee if
necessary.
When the bean container (1) is
empty, wipe it with a dry cloth.
Display shows
Insert brewing unit
Brewing unit (5) is missing
or was not recognised.
Switch o󰀨 the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance.
Display shows
Clean brewing unit
Brewing unit (5) is soiled. Clean brewing unit (5).
Too much pre-ground
co󰀨ee in the brewing
unit (5).
Clean brewing unit (5).
Pour in no more than 2 level
measuring spoons of ground
co󰀨ee.
The brewing unit’s
mechanism is sti󰀨.
Remove and clean the brewing
unit, see “Maintenance and daily
cleaning”.
Display shows
Check water tank
Water tank wrongly
inserted.
Insert water tank correctly.
Carbonated water in the
water tank.
Fill the water tank with fresh tap
water.
Float is stuck in the water
tank.
Remove the tank and clean
thoroughly.
New water lter did not
rinse according to the
instructions.
Rinse the water lter according to
instructions and then switch on.
Air in the water lter. Dip the water lter into water
until no more air bubbles escape,
replace the lter.
Water lter is old. Insert a new water lter.
Display shows
Restart required
Appliance is too warm. Leave the appliance to cool down.
Brewing unit is soiled. Clean the brewing unit.
Display shows
Error
Call hotline
The appliance has a fault. Please call the hotline.
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.