ii
Default washing temperature is displayed after select-
ing the programme, and it can be changed by touching
the button . See Page 42 “Programme Table” for
detail temperature range for each programme.
10
Washing temperature
Programme duration
When the programme has been selected, the expected
programme duration(time after which the programme
is expected to end) is displayed.
When the programme ends, the displays shows
(if select “Rinse hold” function, see Page30).
The programme duration is displayed in hours and
minutes, e.g.
1:17 = 1 hour and 17 minutes
0:35 = 35 minutes.
When the programme starts, the programme
duration counts down in minutes.
While the programme is running, the programme
duration may be extended or reduced for the
following reasons.
Reductions in time occur because of :
small loads,
reduced heating time, e.g. If the water is hot,
reduce the washing temperature after the
programme has started.
the laundry is dry during autodrying programme
Increases in time occur because of:
additional rinse cycle if excessive foam is in the
laundry,
multiple spinning if the laundry is distributed
poorly in the drum,
increased heating times, e.g. when the water is
too cold or “high water level” was selected,
water pressure too low,
very absorbent washing extends the heating
duration.
the laundry is wet during autodrying programme
Max. noise of spinning 66dB(A).
The default spin speed is displayed after selecting
the programme, you can get required max. spin
speed by touching the button.
Spin speed
Cottons
Easy-care Delicates Wool
Single
wash
Single
rinse
Single
spin
rog
ra
m e
P
m
s
Model
Max. S
pin spee
d
(
r/mi
)
n
Individu-
ation
WD 7105 1000
Silver 7125
800 600 800 800 800 1000
1200 800
800
800 600 800 800 800 1200
Silver 7125
1200 800 800 600 800 800 800 1200
Silver 7025 1200 800 800 600 800 800 800 1200
To Next Page
Loading...
