First Wash Cycle
The LCD screen displays “ ” after the
programme finished, the buzzer sounds the
acoustic signal. Turn the programme selector
to “ Off” .
Touch “Start/Pause” button. The programme starts.
Turn the programme selector to “ Cotton
prewash” and set the washing temperature
90 C, “Start/Pause” indicator flashes.
Each machine has been tested in the factory. A
little bit of water can be left in the drum during the
test. Please carry out the first wash cycle without
laundry to remove any water left over from the
factory tests.
The installation of the washing machine is finished.
(see page 44-50)
Do not load any laundry.
Turn the tape ON.
Pull the detergent drawer out as far as it will go.
Input about 1 liter of water in chamber II.
Pour half a measuring cup of detergent into
chamber II. Do not use a special detergent
for delicates or wollens as these will create
too much foam.
Close the detergent drawer.
Close the washer-dryer door.
16
To Next Page
Loading...
