Positioning and connecting en
15
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply ~ Page 30
3. Disconnect the washing machine
from the main plug.
4. Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked ~ Page 29
5. Remove the hoses.
Before initial use:
Notes
■ The transport locks must be
removed. ~ Page 9
■ To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour
approximately 1 litre of water into
compartment II and select and start
the Spin/Drain programme (if only
drain cycle is required, set (Spin
speed) 0 on - - - ).
Installing the transport locks:
1. Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2. Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
To Next Page
Loading...
Need help?
General
