Faults and what to do about them en
31
6. For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance,
Remove the filter using pliers and
clean the filter.
7. Connect the hose and check for
leaks.
3 Faults and what to do
about them
Faults and what to do about them
Emergency release
e.g. in the event of a power outage
Note: The programme will continue
running when the power supply has
been restored.
:Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning. Wait until the drum has stopped
turning.
Caution!
Water damage
Any escaping water may cause water
damage. Do not open the washing
machine door if water can be seen
through the glass.
If the laundry has to be removed, the
washing machine door can be opened
as follows:
1. Switch off the appliance.
2. Disconnect the mains plug.
3. Drain the water. ~ Page 29
4. Pull the emergency release
downwards with a tool and release.
The washing machine door can now
be opened.
To Next Page
Loading...
Need help?
General
