en Setting the signal
28
M Setting the signal
Setting the signal
1. Activate the setting mode for the signal volume
Set to Ú. Press and hold the 0 button and turn one
position to the right.
Press and hold the button for
approx. five seconds until the
display elements light up. Set-
ting mode is activated.
2. Set the volume for the button signals (depending on the model)
Press the button repeatedly until the
desired volume is reached.
Go to point
3 or
Set to Ú to exit the setting mode for the signal volume.
3. Set the volume for the information signals
Turn the dial one position to the right. Press the button repeat-
edly until the desired vol-
ume is reached.
Set to Ú to exit the setting mode for
the signal volume.
To Next Page
Loading...
