Siemens WM16XKH1ES - Setting a Programme; Adjusting the Programme Set- Tings; Loading Laundry

en Basic operation
38
It may take a few seconds for the
appliance to switch on.
a The appliance performs an audible
function test in the detergent
drawer.
→"Noise", Page61
Note:The drum is lit up after the
door is opened and closed and once
the programme has started. The light
goes out automatically.
Setting a programme
1. Set the programme selector to the
required "programme" →Page27.
2. If necessary, "adjust the pro-
gramme settings" →Page38.
Adjusting the programme set-
tings
Depending on the programme and
programme progress, you can adjust
or activate/deactivate the settings.
Note:Overview of all programme set-
tings:
→"Buttons", Page25
Requirement:A programme has
been set.
▶
Adjust the programme settings.
The programme settings are not
saved permanently for the pro-
gramme.
Note:The setting is saved if you ac-
tivate or deactivate the intelligent
dosing system.
Loading laundry
Notes
¡ Please read the information in the
"Safety" →Page4 and "Preventing
material damage" →Page11 sec-
tions to ensure that you use the
appliance safely.
¡ To prevent creasing, take note of
the maximum load for the relevant
"programme" →Page27.
Requirement:Prepare and sort the
laundry.
→"Laundry", Page34
1. Open the door.
2. Ensure that the drum is empty.
3. Separate the laundry and place it
in the drum.
4. Note:Ensure that there is no laun-
dry trapped in the door.
Close the door.