- 10 -
2.2.1. Connecting the CUP+ Terminal Board
Terminal board – output connection,
utilizes the shared terminal connection
RS 485 data line – brought out at two
places in parallel: As a system
connector for service interventions
and onto the terminal board with
screwed terminals for permanent
installation. Just one line may be
connected at a time.
Tamper terminal board – connection
of external protective contact (tamper)
from the assembly box or another
cover, NC contact
Supply terminal board – supply
voltage of 9 – 16 VDC
ETH connector – for connecting
CUP+ to the data network,
communicating with other elements
in the data network, communication
with other network elements,
IOP/LAN, cameras using the Onvif
protocol
RS 232 data line – used for connection
of the LCP modules, it is possible to
use standard UTP patchcord
Micro SD slot – memory card slot for
purposes of saving logs, configuration
etc.
To Next Page
Loading...