Sieza Peridect+

To Next Page

To Previous Page

- 1 -

Contents

Introduction – basic description of PERIDECT+ ..................................................... - 2 -

1.1. Purpose of the System .............................................................................. - 2 -

1.2. System Topology ...................................................................................... - 2 -

2. HW of the PERIDECT+ System ................................................................................. - 3 -

2.1. PERIDECT+ Detection Line ...................................................................... - 3 -

2.1.1. Standard Version ................................................................................ - 4 -

2.1.2. Antivandal Version .............................................................................. - 5 -

2.1.3. Hidden Version ................................................................................... - 6 -

2.1.4. Installing the Perimeter onto the Fence ............................................... - 7 -

2.2. CUP+ – Control Unit PERIDECT+ ............................................................. - 9 -

2.2.1. Connecting the CUP+ Terminal Board .............................................. - 10 -

2.3. LCP+ – Line Controller PERIDECT+ ....................................................... - 12 -

2.3.1. Connecting the LCP+ Terminal Board ............................................... - 12 -

2.3.2. LED Signalling of CUP+ and LCP+ ................................................... - 13 -

2.4. LIP+ – Line Input PERIDECT+ ................................................................ - 13 -

2.5. LPP+ – Line Protection PERIDECT+ ...................................................... - 13 -

2.6. IOP+/LAN/RS485 I/O Module PERIDECT+ ............................................. - 14 -

2.6.1. Connecting the IOP+ Terminal Board ............................................... - 14 -

2.7. LSP+ – Line Separator PERIDECT+ ....................................................... - 15 -

2.8. Block Diagram of the System .................................................................. - 15 -

3. Technical Specification of PERIDECT+ .................................................................. - 16 -

3.1. PERIDECT+ CUP+ Control Unit.............................................................. - 16 -

3.2. PERIDECT+ LCP+ Line Controller .......................................................... - 16 -

3.3. PERIDECT+ LIP+ Line Input ................................................................... - 16 -

3.4. PERIDECT+ DSP+ Detection Sensor ..................................................... - 16 -

3.5. PERIDECT+ LSP+ Line Separator .......................................................... - 16 -

3.6. PERIDECT+ IOP+/LAN I/O Module ........................................................ - 17 -

3.7. PERIDECT+ IOP+/RS485 I/O RS485 Module ......................................... - 17 -

3.8. PERIDECT+ IOP+/EXP I/O Expansion Module ....................................... - 17 -

Sieza Peridect+ - Page 2