Sigineer Power 48V60 User Manual

13
05
Bulk charging voltage
(C.V voltage)
48V mode: default 56.4V, 48.0V~58.4V Settable
24V mode: default 28.2V, 24.0V~29.2V Settable
12V mode: default 14.1V, 12.0V~14.6V Settable
If “Li” is selected ,it can’t be set up
06
Floating charging
voltage
48V mode: default 54.0V, 48.0V~58.4V Settable
24V mode: default 27.0V, 24.0V~29.2V Settable
12V mode: default 13.5V, 12.0V~14.6V Settable
If “Li” is selected ,it can’t be set up
07
Low DC cut-off voltage
48V mode: default 42.0V, 40.0V~48.0V Settable
24V mode: default 21.0V, 20.0V~24.0V Settable
12V mode: default 10.5V, 10.0V~12.0V Settable
48V Li model: default 20%,5%~50% Settable
08
Communication mode
SIG (default), used to communicate with upper computer
CL1, used to communicate through RS485
CL2, used to communicate through CAN.
09
RS485
Communication
Address
Protocol 1 (default)
Used to communicate with controller in CL1 or CL2, or used to
communicate with upper computer in SIG
10
Battery equalization
If ”Flooded” or ”User-Defined” is selected in program this program can
be set up.

Sigineer Power 48V60 Specifications

General

Brand	Sigineer Power
Model	48V60
Category	Controller
Language	English