116
C4 Manual Rev 7.5.2
WP Set PID constants ............................................ 67
PN Select active (control) probe ....................................... 70
Ports............................................................. 10
Aux/power control port control ..................................... 52
connector ...................................................... 22
Cryogenic boost control ........................................... 52
EIA-232 ....................................................... 55
IEEE488 (GPIB) ................................................ 55
Outputs and input, installation and use ............................. 98
Refrigeration compressor control ................................... 52
TO & TF Turn aux/power control port on & off........................ 72
TTL ........................................................ 52, 98
Power
2nd power cords WARNING ...................................... 101
Disconnecting.................................................. 101
Probe
Number of probes................................................ 82
PN Select active (control) probe .................................... 70
Probe correction (software probe calibration).......................... 83
Specifying active (control) probe for program.......................... 43
Probe 2
No probe 2 error .............................................. 49, 50
Probe averaging.................................................... 35
Probe connections .................................................. 22
Probe correction (calibration) ...................................... 32, 80
Entering probe correction setup data ................................ 84
SC Set probe correction ........................................... 66
Probe out of range shutdown ......................................... 29
Clearing ....................................................... 30
Effect of probe correction.......................................... 30
Error/Status String reporting ...................................... 30
Probes, number installed, defining .................................... 79
Program
Aux/power control port control ..................................... 52
Displaying step number while running .............................. 49
Interrupting/restarting ........................................... 48
Looping ........................................................ 51
Looping forever ................................................. 49
Pre-read Errors ................................................. 49
Refrigeration compressor control ................................... 52
Running (executing) .............................................. 48
Program memory, clearing ........................................... 46
Program mode .................................................. 10, 43
Control/program example(s) ....................................... 87
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...