Sigma 1-14K - Power Supply; Connection; Fuses on Site

1-14K
Set-up and Connection
22 Version 05/2010, Rev. 1.8 of 01/09/2011- sb
Translation of the original operating manual
5.4 Power Supply
5.4.1 Connection
The operating voltage on the name plate must correspond to the local
supply voltage!
• This SIGMA laboratory centrifuge is a unit of safety class I
and has a three-wire power cord with a IEC C13 connector.
5.4.2 Fuses on site
Typically, the centrifuges must be protected on-site with 16 Amp L or
B fuses.