1-14K
Using the Centrifuge
Version 05/2010, Rev. 1.8 of 01/09/2011- sb 31
Translation of the original operating manual
6.3.9 Programs
The program is used to save or load certain recurrent settings of the
centrifuge. 10 different programs can be saved and called up. The
precooling program "precool" does not occupy any storage location
and cannot be deleted. It is used to cool the centrifuge without
vessels (see 6.3.7.5).
6.3.9.1 Saving the current settings
• Press the program key. Then, select a program number by
pressing the arrow keys. The display "Prog - - " will now flash.
• Select the correct rotor.
• Press the “set” key repeatedly until the corresponding unit flashes
on the display. Select the desired parameters.
• In order to save the data, start the centrifuge or press the "set"
key repeatedly until the indication "Prog - -" stops flashing.
Program numbers that are already occupied will be overwritten with
the current data.
6.3.9.2 Calling up stored programs
• Press the program key. Then, select a program number by
pressing the arrow keys. The display "Prog - - " will now flash.
• Ensure that the correct rotor is selected.
• In order to save the data, start the centrifuge or press the "set"
key repeatedly until the indication "Prog - -" stops flashing.
6.4 Switching the Centrifuge OFF
• Open the centrifuge when it is not in use so moisture can
evaporate. This prevents the increased wear of the motor
bearings.
• Press the mains power switch.
To Next Page
Loading...
