Refrigerated Centrifuge Sigma 1-16K
Refrigerated Centrifuge Sigma 1-16K IVD
Version 10/2013, Rev. 2.21 of 08/05/2020 • sb
Translation of the original operating manual, part no. 0700302
6.2.2.3 Installation of accessories
• Only use tubes that are suitable for the rotor.
• Always load the axial symmetrical inserts of the rotors with the same
accessories and fill to avoid imbalance.
Centrifugation with low capacity
• Install the tubes axial symmetrically so that the rotor is loaded evenly.
• It is not permissible to load angle rotors on only one axis.
Fig. 6: Permissible and impermissible loading of an angle rotor (example illustration)
6.2.2.4 Vessels
• Load the vessels outside of the centrifuge. Liquids in the bores of the
rotor cause corrosion.
• Fill the vessels carefully and arrange them according to their weight.
Imbalances result in the excessive wear of the bearings.
• Follow the safety instructions and hazard warnings (see chapter 3 -
"Safety")!
To Next Page
Loading...
