66
www.sigmasport.com
7 TRAINING WITH LAPS
7.3.4 DISPLAYING VALUES FOR INDIVIDUAL LAPS
7.4 FAQ (FREQUENTLY ASKED QUESTIONS AND SERVICES)
You can re-view the different measured values for the individual laps.
Prerequisite: Your heart rate monitor must be in training mode.
1 Hold down the LAP button until the lap view opens.
A value from the last lap is displayed.
2 Select a lap.
Press the LAP or the START/STOP button to scroll through
the laps.
3 Press the TOGGLE (-) or TOGGLE (+) button to view the
corresponding lap values.
4 Exit lap view.
Hold down the LAP button. The training mode is displayed.
What happens if I remove the chest belt during training?
The watch will no longer receive a signal. The screen will indicate “O”
and after a short period of time the PC 15.11 will go into sleep mode.
Does the SIGMA heart rate monitor completely switch off?
No – only the time and date are displayed in sleep mode so that you can
also use the heart rate monitor as a normal watch. The PC 15.11 uses
very little power in this state.
To Next Page
Loading...
