ROX 6.0 Page 16
Setting the language
Basic settings
4 Basic settings
Press and hold the
Set
button for three seconds. “Setting OPEN” flashes on the
display. The preset language then appears.
If you are using the ROX 6.0 for the first time and awakening it from deep sleep
mode, it will automatically jump to setting mode without pressing and holding the
Set
button.
Caution
The ROX 6.0 can also be set during a ride. Not advised and please do so with
caution.
4.1 Setting the language
1 Press the
Mode 1
button to switch to the preset language.
2 Press the
Set
button. The display flashes.
3 Press
Mode 2
or
Reset
to select the desired language.
4 Press the
Set
button to save your setting.
“Set OK” appears on the display.
4.2 Setting the unit of measure
1 Press the
Mode 1
button to switch to the preset unit.
2 Press the
Set
button. The display flashes.
3 Press
Mode 2
or
Reset
to switch between km/h and mph.
4 Press the
Set
button to save your setting.
“Set OK” appears on the display.
4.3 Setting the air pressure at sea level
Explanations about this function can be found in section “7 Altitude measurement
(IAC)”.
1 Press the
Mode 1
button to switch to the preset air pressure.
2 Press the
Set
button. The display flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Set
button to save your setting.
“Set OK” appears on the display.
Set
Mode 2Reset
Mode 1Set
Mode 2Reset
Mode 1Set
Mode 2Reset
Mode 1Set
To Next Page
Loading...
Need help?
General
