Sigma Rox 6.0 - Actual Altitude Setting; Home Altitude Setting; Wheel Size Setup

ROX 6.0
www.sigmasport.com
ROX 6.0 Page 17
Setting the actual altitude
Basic settings
4.4 Setting the actual altitude
Explanations about this function can be found in section “7 Altitude measurement
(IAC)”.
1 Press the
Mode 1
button to switch to the preset altitude.
2 Press the
Set
button. The first digit for entry flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Mode 1
button to switch to the next digit.
5 Press the
Set
button to save your setting.
“Set OK” appears on the display.
4.5 Setting the home altitude
Explanations about this function can be found in section “7 Altitude measurement
(IAC)”.
1 Press the
Mode 1
button to switch to the preset start altitude.
2 Press the
Set
button. The first digit for entry flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Mode 1
button to switch to the next digit.
5 Press the
Set
button to save your setting.
“Set OK” appears on the display.
4.6 Setting the wheel size for bike 1 or bike 2
1 Press the
Mode 1
button to switch to the preset wheel size 1 or wheel size 2.
2 Press the
Set
button. The first digit for entry flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Mode 1
button to switch to the next digit.
5 Press the
Set
button to save your setting.
“Set OK” appears on the display.
4.6.1 Calculating the wheel size
There are three ways to determine the wheel size:
− Follow instructions in Figure A or B
− Find in the table (Figure C) based on tire size.
Mode 2Reset
Mode 1Set
Mode 2Reset
Mode 1Set
Mode 2Reset
Mode 1Set